Bed Pad Alarm Replacement Pad is a replacement pressure-sensitive pad for use with existing bed alarm systems. When a bed alarm pad becomes worn or less responsive, replacing it with a new pad restores the reliability of the fall detection system without the cost of replacing the full alarm unit.

Regular inspection and timely replacement of alarm pads is an important part of maintaining a safe patient environment. OxyCare stocks replacement bed alarm pads and can advise on compatibility with your existing alarm equipment.

Operating Instructions

Emergency telephone number is on your equipment. (618)234-0202

Please follow instructions given by the equipment technician. Please follow your doctor's orders.

Set-up Magnetic Clip Alarm

1. Attach magnetic alarm to wheelchair or bed.
2. Place magnetic sensor in the sensor area.
3. Clip cord to a piece of clothing the patient is not likely to remove, and out of patient's reach.
4. A pull on the cord will cause the magnetic sensor to release sounding the alarm.
5. Stop alarm either by replacing the magnetic sensor or turning the unit off.
6. Patient/Caregiver demonstrates each step and has a solid understanding.

Set-up Pressure Pad Alarm

• Select desired alarm and volume settings.
• Attach monitor to wheelchair, chair or bed using attached metal clip.
• Place the pad on chair or bed so the bulk of the patient's weight is resting on it. Plug the end of the pad cable into the pad jack on the bottom of the monitor.
• When the patient moves from the pad, the selected alarm tone sounds to remind the patient to sit or lay back down and alerts the caregiver that the patient is at risk of falling. The alarm signal shuts off when patient returns to the pad or the monitor is reset using the 2 button reset.
• Patient/Caregiver demonstrates each step and has a solid understanding.

Cleaning

Clean monitor and pad as necessary by wiping with clean cloth.

Safety

• Test the alarm before each use. Inspect the pads and monitor regularly to be sure they are not damaged.
• Long cords can entangle with patient and be potentially dangerous. Use care and supervision.
• Do not place magnet closer than 6 inches of an implanted device.
• Alarms should be used in conjunction with an approved fall management program. It is not intended as a substitute for appropriate patient monitoring techniques.

OxyCare Medical Supply Co. 2725 South Belt West, Belleville IL 62226